Granite Falls Bridge 102 Replacement
August 2017 Update
Granite Falls Bridge 102 has completed the 30% design review milestone. This means the type of bridge, materials and right of way have been completed for this project. Snohomish County has applied for several grants and funding sources for this project, but has not been selected. The county will continue to apply for funding to compete the design and construction phases of this project.
An Important Economic Corrido
Granite Falls Bridge 102 is the gateway to an important economic and recreational corridor. It spans the Stillaguamish River approximately 1.5 miles northeast of downtown Granite Falls, and is part of the 52-mile Mountain Loop Scenic Byway between Granite Falls and Darrington.
The bridge and corridor provides access to homes, vacation properties, sand and gravel quarries and logging operations as well as many square miles of hiking, camping, and other outdoor recreation activities. The Granite Falls Bridge is part of a larger program to increase freight mobility and capacity through the area.
Phase I: Granite Falls Alternate Route or Quarry Road
On November 19, 2010, a 1.9-mile truck route that diverts freight traffic around downtown Granite Falls was completed. The new alternative route has three roundabouts in contrast to three stop signs and one traffic signal on the old route. Truckers save time and gas on this new route, reduce engine emissions and experience a smoother ride, while Granite Falls residents and visitors now enjoy a safer, and pedestrian-friendlier, downtown.
Phase II: Bridge Replacement
The current bridge is a two-lane, 10-foot-wide, 340-foot long, structure built in 1934. Snohomish County Public Works is planning to replace the bridge when construction funds become available. The Phase II Bridge Replacement project has reached a 30% design milestone and is currently on hold until further grant funding becomes available.
The proposed plan is to construct a new bridge just west (on the downstream side) of the existing bridge. The current bridge will remain in place to provide for traffic corridor needs throughout the new construction. The proposed bridge replacement is planned as a 351-foot long two span, steel girder bridge; the bridge will have two 15-foot lanes and two sidewalks.
The new bridge will be wider and longer than the existing bridge and will meet current bridge standards.
Snohomish County is seeking funding in order to proceed with plans to replace the bridge (view funding strategy information). At this time the Phase II Bridge Replacement Project is on hold.
- ROW Phase: Completed 2017
- Milestone 30% design completed
- Snohomish County will continue to apply for grants to finish design and construction